Profile Impact Pads
APPLICATION: Profile Impact Pads should be used in areas (chutes and hoppers) where the material impacts at a 25° to 65° angle. This will create a surface that can rebound these high angled impacts.
#101 Urethane (90A Durometer) Plain - No Backing
| Standard sheet size: |
51 3/8" Wide X 54" Long X 1 1/2" Thick
Ribs run parallel to 51 3/8" dimension.
|
| Installation: |
Bolt through "valley" to chute on approximately 16" center to center. |
#262 Rubber (60 Durometer)
| Sizes Available: |
Even one foot sizes - i.e.: 12" X 12", 12" X 24", 36" X 48"
Maximum size - 48" X 48"
|
| Thickness Available: |
2", 2 ½", 3" |
| The following are available at additional cost: |
| |
3/16" Thick Steel Backing
Counterbored Bolt Holes
Stud Bolts |
|